In Driver Mode Engine Temp information has stopped showing

[jjeff1955]

The Engine temperature info was shown above the Driver's Picture and started to become intermittent sometimes will show and sometimes not.
It was good to be able to see the Diesel name & engine temp specs related to the top SD70 Radiator fans that would start when the temp would hit 180 degrees then stop at under 174 degrees.

Now has completely stopped showing that info. I tried trial and error with the engine sound config but no resolve to get it to show again.
I did not change the engine spec asset.

The latest <kuid2:45324:555246:7> Jointed Rail Train Effects library v 1.46d breaks the compressor sounds,
I had to revert to the older one <kuid2:45324:555246:7> Jointed Rail Train Effects library v 1.46d,
and now the Compressor sound effects are working again.
ANy hepl with this issue would greatly be appreciated.

 

[norfolksouthern37]

Do you mean the debug info? You can turn this on in the JR settings but it wasn't really supposed to be a general readout of information as it can get very crowded. Perhaps I could give engine temp and load information in it's details dialog.

Interesting report on the compressor sounds. This is a very old part of the code and doesn't change between versions much anymore.

 

[jjeff1955]

Do you mean the debug info? You can turn this on in the JR settings but it wasn't really supposed to be a general readout of information as it can get very crowded. Perhaps I could give engine temp and load information in it's details dialog.

Interesting report on the compressor sounds. This is a very old part of the code and doesn't change between versions much anymore.

Thank You my good friend

I will try the debug settings on and see if that works.
The weird thing is I did not change any of those settings when it stopped working.
When I downloaded your latest version of the FX Library 2025 the compressor stopped working. I then deleted the latest version and it reverted back to the 2020 version and the Compressor started working again.
Trainz 2022 is just very weird of what it wants to do.

Thank You again!

 

[jjeff1955]

I turned on debug and still did not show the messages above the driver in Driver mode.
Update on the <kuid2:45324:555246:7> Jointed Rail Train Effects library v 1.46d-2025.
It is working ok after I did a full database repair.
It was a typical Trainz issue.