Faulty Dependencies

[mp143]

Hello again. This time my question involves faulty dependencies, and how to fix them. I have downloaded a DT&I painted GP38-2 from the DLS, and it is reporting faulty dependencies with both front and rear couplers. The error message for said dependencies was: "Error: This asset has a trainz-build number which is not recognised by this tool." Is there a fix for this, or no?

(Note: this member is not as technically advanced as others, so try to simplify as best as possible please )


mp143

 

[robin_hoods]

It is probably the fact that the dependency builds are 3.3 or above so TS2010 wont recognise the build you may be able to open the configs and change the build to 2.9 which TS2010 will recognise dont forget to commit once you have saved the changes

 

[xcrossi]

I search DT&I came up version 1.3
Give me a couple of minutes I have to fire up trz 10

I just downloaded all 3 and the errors are not the ones you posted.

 

[mp143]

I search DT&I came up version 1.3
Give me a couple of minutes I have to fire up trz 10

I just downloaded all 3 and the errors are not the ones you posted.

Odd, which errors did you get? The engine i downloaded was GTW (ex-DT&I) 6221

 

[xcrossi]

All 3 same errors

Warning: Progressive meshes are no longer supported by Trainz. Though these meshes may work in Trainz, it is recommended that you switch to a LOD mesh.
Warning: Progressive meshes are no longer supported by Trainz. Though these meshes may work in Trainz, it is recommended that you switch to a LOD mesh.
Error: Unable to load mesh file: 'GP38-2 GTW 6226 ex-DT&I_shadow\GP38-2 GTW 6226 ex-DT&I_shadow.pm'

 

[mp143]

All 3 same errors

Warning: Progressive meshes are no longer supported by Trainz. Though these meshes may work in Trainz, it is recommended that you switch to a LOD mesh.
Warning: Progressive meshes are no longer supported by Trainz. Though these meshes may work in Trainz, it is recommended that you switch to a LOD mesh.
Error: Unable to load mesh file: 'GP38-2 GTW 6226 ex-DT&I_shadow\GP38-2 GTW 6226 ex-DT&I_shadow.pm'

Ohhh, OK. Yes, that was the error I first got. I also had downloaded an updated version of the couplers to see if they worked, and the updated ones gave me the build number error. I don't think the updated one were compatible with the engine either. Oops....

So, how do I fix the mesh file error?

 

[xcrossi]

So, how do I fix the mesh file error?

You see now it can get complicated.
Download PM2IM and install.
When in CM3.3 and asset is highlighted right click open with / PM2IM.bat

 

[xcrossi]

I can't find the link to PEV's tools

 

[mp143]

I can't find the link to PEV's tools

While you looked, I tried robin_hoods method, and it actually fixed them! Thank you very much for the help though, I saved the PM2IM link in case i need it later.

 

[xcrossi]

Actuality PEV has a set of tools that can fix 95% of all assets