Editing the Driver schedule while in session

[theedge2k]

I have setup one of my AI drivers to drive a schedule which consists on "coupling" to freight car and then driving to the freight car then hauling to to unload and then i have it set to repeat. My question: Is there away or a rule to remove the "couple" command from the schedule during the session., besides doing it manually?

 

[Paul_Bert]

I would set up in the schedule library two sets of commands: the first with the couple/uncouple command and the second one omitting it. Use the 'copy commands from' and insert the first library command, then 'enable repeat' and then finally the second library command. What this does is the first time the train will perform the couple/uncouple action and then in the future repeats of the route this action will not be performed.

I am assuming that this is what you are looking for?

 

[fran1]

No not during a session, by manually I take it you mean sliding it out before the driver uses that command. If you are in saved sessions slide the command out as and when you need. When you add to the route in surveyor do as the other reply suggests.