Hi all, did a previous post on my turnout arrows not showing on my route in certain parts. Did some cleaning up of the placement of junction arrows in surveyor. Not that i think that is the problem, as all the arrows show in surveyor, it seems to be the save process in driver, and not limited to a certain part of my route. If i start a new driver session everything seems fine although i did have one part of my route not showing junction arrows. This just seems so random and quite frustrating as my route is huge, and needs a few days to navigate around not that i have managed it yet owing to the aforesaid problem its a bit hard going somewhere when you cannot change the direction you want to go. So saving and coming back is the only way. Maybe some faulty content somewhere, but who knows. All the parts of my route as i built it were seperate sessions, as suggested by someone else on the forums, as i had almost 160 times i had edited my route and it never went to the last one i worked on, until i seperated my sessions and knew where i left off. Now that it is almost finished i would like to get driving except for this glitch. Sorry for the ramble but if anybody has any ideas. Cheers.