Drive and Navigate Via commands

[Mick_Berg]

What happened to these commands? Seems they suddenly don't exist. They were useful for guiding a train to or through a station (or other industry) without stopping.

Mick

 

[pware]

They are still there. I was experimenting with "Navigate Via Trackmark" just the other day and it worked fine.

Check that they have been enabled in the Driver Commands Rule in the Session Editor.

 

[clam1952]

Some commands I have noticed didn't survive from SP2 to SP2HF4 and just need adding again, may not be helping with the apparent AI issues.
I lost set camera, drive via and a couple of others, easily put back though.

 

[Mick_Berg]

Hi Peter and Malc
You are both missing the point of my post. I am talking about "Drive To" and "Navigate Via" specifically. I know about "Drive to Trackmark", not the same thing. I have looked on the DLS and the commands I am talking about are not there AFAICT.

Thanks
Mick

 

[clam1952]

Might want to check your base assets:

<kuid:-3:11058> Drive To which is listed in Game has always been a base asset therefore will never be on the DLS as it's installed as a base asset.





Navigate via? Sure you don't mean Navigate via Trackmark? also a base asset. No Navigate via in TS12 either.

 

[pware]

"Navigate Via ..." and "Drive Via .." (and "Autodrive Via .." for that matter) have always been "Via Trackmark". I have never seen a "Navigate Via <industry or station name>"

 

[Mick_Berg]

"Navigate Via ..." and "Drive Via .." (and "Autodrive Via .." for that matter) have always been "Via Trackmark". I have never seen a "Navigate Via <industry or station name>"

I was sure that there used to be "Drive Via" and "Navigate Via" commands, (exactly that), that you could use to go through a station without stopping, if you wanted to guide a train through a particular path without needing a trackmark. But it seems now, with input from well-respected Trainzers, that I may have remembered incorrectly. Could anyone else chime in and confirm or deny?


Thanks,
Mick

 

[p-dehnert]

On the DLS there is DriveViaIndustry06,<kuid:131986:1065> by atilabarut. He has a lot more commands at the DLS, mostly TRS2004/6.

Peter

 

[Ghost42]

Another one with stationary consists, when programming the schedule I used 'Drive via trackmark' which on-screen has changed to 'Drive to'.
Changed to 'Navigate via', now testing.
All ok