Could I please ask someone whose using the "ControlDiamCross" driver command to help me out in understanding the instructions that come with the command. I'm confused as to what i'm surposed to tipe into the InputTable rule.
dcross = ?
control_name = ?
control_trackmark = ?
release_trackmark = ?
signal_1,signal_2 = ?
Are all these commands surposed to go on a single line?
It says "dcross" should be a command name that can be recognized by driver command. I'm not sure just what that means. Any help would be appreciated.
dcross = ?
control_name = ?
control_trackmark = ?
release_trackmark = ?
signal_1,signal_2 = ?
Are all these commands surposed to go on a single line?
It says "dcross" should be a command name that can be recognized by driver command. I'm not sure just what that means. Any help would be appreciated.