Diferencies betuneen Drive to, Navigate to, and drive or navegante "vía"

[angelsd]

Hi:

i'm starting to use Trainz and I've found a lack of documentation. There are not information about the drivers commands. Now I need to know the diferencies between "Drive" and "Navigate", I supone that "Vía" means to go that point and continúe and "To" is for go and stop, is that correct?

Please let me know about these two issues.

I have create a test circuit with Stations and Trackmarks but the Driver command avilable are only "Navidate To" or "Drive To" but not ...."Vía" and neither ....to Trackmark or vía trackmarks., I have many of then.

 

[stagecoach]

Drive to :- will list stations or industries that can load/unload
Drive to TM :- will drive to the selected TM and stop
Drive via TM :- will drive through the TM without stopping
Drive or navigate, I think someone mentioned that drive is more direct while navigate the train will search alternatives if route blocked.
When in session open the driver command tab by selecting and then click edit. All the commands are listed, just tick the ones you want to use, unticked ones wont show in the game.

 

[angelsd]

Thank you. Now the diferencies are clear for me.

For the secund topic, I have selected all command but later when I wont to select one of them for a specific driver, not all are displayed.

 

[stagecoach]

There are a couple that you cant select while in surveyor session. Trainz assumes that as you set up the route they are not required during the surveyor session, uncouple is one such command. You can find alternative commands on the DLS that can be used, Uncouplez is the replacement for uncouple and can be selected in surveyor sessions.