Decker NG3 industry

Richard_Dodge

New member
Hello to all. this might have addressed befor but her goes anyway. Wondering how "Decker NG3 industry" works!!
I have layed narrow gauge track down and set and lined up "Decker NG3"over the track just layed. In drive mode the log cars just pass thrugh"Decker" and do not climb up the decker rails.
Would like to know what is the correct procedure in connecting Decker to the rails.
Just a side note: I have successfully operated Decker by connecting track to each end. The log cars climb up and over the decker rails then I reverse and stop in front of Decker to load logs.
Would like to have "Decker" setting on the track as it should and work properly.
Thank you and have agood day.
Richard
 
just place some unconnected track underneath. holding shift while laying track revents the splime points form connecting and causing problems. Just line up the short bit of unconnected track so it looks good and there you are.:D

Hope this helps.
 
Hello to all. this might have addressed befor but her goes anyway. Wondering how "Decker NG3 industry" works!!
I have layed narrow gauge track down and set and lined up "Decker NG3"over the track just layed. In drive mode the log cars just pass thrugh"Decker" and do not climb up the decker rails.
Would like to know what is the correct procedure in connecting Decker to the rails.
Just a side note: I have successfully operated Decker by connecting track to each end. The log cars climb up and over the decker rails then I reverse and stop in front of Decker to load logs.
Would like to have "Decker" setting on the track as it should and work properly.
Thank you and have agood day.
Richard

Hi Richard,

I guess you've found out how it works. It is like any other industry, you have to connect the track to it to make it work. Having it just sitting there looks ok, but it will not work.

Cheers,
Bill69
 
Back
Top