bus routes

[georgewcato]

hello I am doing a map with bus routes within and I am using Uk bus stops in the scheme. I would like to have the routes set and the buses to stop at all stops without having to list them individually in the driver list ,so what I am asking is there a rule that I could use for the buses to stop at all industies as this what the bus stops show as find objects and if I did have to list them individually the list would be massive . manythanks George

 

[airtime]

I think this is a great idea, it could be used for railway stations and tram stations too, so a local train would stop at all local stations along the route.

If every stop and station was named as "station" and more than one along the route would be known as "station one", "station two" and so on..., and a command was set to "call at all stations", then this would be a lot easier than call at this station, load, wait for 30 seconds, call at next station and so on...

Whether this can be done is another question, but I do like the idea, and it would make it so much easier than setting each command.

Joe Airtime

 

[tdstead]

Some Info

When the V6e layot was released it had something like that but the routing is designed for there vehicles, they read the route number from the vehicle at points. if the route had no points each route was seperate maybe the buses would obey the stop commands. it is payware !.

Tom