Brickworks

[stouthm]

I've been using Stryker's Brickworks for years but now out of the blue I can't get the loco to 'drive to' the drying shed to pick up a load of bricks. All it does is drive to the "coal bunker". The "drying shed" doesn't even register. It shows on the menu but when I select it for a destination it shows as the "coal bunker". I tried it in route-layer and session-layer, did a "data base repair", deleted it and did a fresh download but no luck. Any ideas as to what is happening or better yet some suggestions? Thanks for reading this.

 

[p-dehnert]

The 'drying shed' and the 'coal bunker' use the same track. The commands only store the internal trackname, not the destination name. When looking up the destinationname for the tooltip, they use the first destinationname with a matching trackname for display.

Peter

 

[stouthm]

Thank you for responding. I found that out about 3 hours ago and was just going to report that in this thread. Live and learn.