Auran Track Ts 2009 Taking over???

railroy19

New member
What can we do about this Auran track?

I have so many routes in 2009 that have all the roads changed over to the Auran trackts2009 I tried to delete the kuid number in the config file but that does not work.
Why is this happening on so many routes? Is there a remedy for this?:(

What do you people do about it.

Bob
 
Hi Railroy19,

I thought this would happen only if you don't have the required road in your 2009 database, however I could be wrong. For built in objects, you can't delete them but you can disable them in CMP. I would try disabling them and see what happens then. However the track may still appear on routes you have already loaded.

Cheers,
Bill69
 
Hi Bill69

I'm not sure what is going on!
I don't understand why if the road or fence that is beeing replaced by the track is not in my contents why are the kuid's not being shown in dependencies in cmp. If any other assets are missing they just do not show up in the route and you can just delete missing assets. I had these routes even before 2009 was introduced, and the roads were fine. :confused:

Bob
 
The program replaces any missing spline asset or faulty spline assets with the track to preserve the spline points and allow you to use the replace asset tool to replace the items. You have three options:

1. Find the assets if they are missing and install them.
2. If the asset is faulty it will not show in Native mode so you have to repair the asset.
3. Change to compatibility mode so that the program will use the broken asset anyway.

William
 
Back
Top