ATLS Triggers in surveyor?

[railsong]

I have just started using the ATLS system for a level crossing which uses crossing gates and lights. When I place the controller and the slave in position they show up in surveyor, but when I place the triggers they do not show up in surveyor. I don't know if they are not getting placed or not. Would appreciate any help...Thanks.....
Mel

 

[hert]

We need some clarification:

What Trainz version are you using?

Do you see the trigger in the little window below the names?

You might need to delete them in CMP/CM and redownload them

hert:wave:

 

[railsong]

I am using Trainz 2010EE edition. I am trying to control the Grade Xing NRC LED Gated KUID 39134:102036. The Green cross trigger does show up in my menus. I just don't see it in surveyor when I try to place them. Hope this helps, I sure need some instructions....It does seem to be installed as the trigger icon shows up when I bring it up to place it on the track...

 

[hert]

Make sure when you place them you click right in the middle of the track.

hert:wave:

 

[boat]

They should show up OK. For placement just treat them the same as an ordinary Auran green Trigger.

As Hert suggested, re-download, (and make sure you have the latest version which is kuid2:76656:500016:3)

Boat

 

[railsong]

Thanks to both Hert and Boat for the advice. I deleted the trigger item and re-downloaded it and it is working fine now... Thanks again I sure appreciate the help......
Mel

 

[angelah]

Good assets

You will find these are very good assets and I am using them on the second section of my long route to Westbury in Somerset after practicing how to set them up on a test map.
Just remember to number each crossing or bridge in sequence. You can place the Approach triggers well away from a crossings which will cause them to close the gates/barriers some time before the train arrives, very prototypical.
They work just as well with bridges too.
But if you are creating a route and save out to a second version you will need to reset all the crossings because the details are not stored. It's no great problem.
And thanks to Boat for creating them.

Angela

 

[railsong]

Yes, thanks to boat for the great ATLS system. I sure like working with them. Before I said I was having trouble placing the ATLS triggers. I am still having some bad luck with them getting placed or of moving them. It seems when working in surveyor and when I try to move or delete them, it won't let me. I can then exit the game and load it up again and then they work OK. Don't know what is causing this.....
Mel