All my SD70s acting weird - TS2009

[Trainboy103]

Hello,
I noticed this problem happened in the TS2006 version, but whenever i Drive the SD70's in DCC mode the throttle dial will return to the center position (stop) unless i click it enough to get the train above 10 MPH, then the problem goes away. Anybody know whats wrong?

 

[rjw1975]

The SD70`s that come installed in the game are industry interactive so you have to fuel them up before you use them. Either do this at a fuel depot or go into surveyor, click on properties for the loco and set the fuel level to the full amount so that it`s already full when you go to use it.

 

[trainman3801]

I am also having problems whith SD70's. I will give go to give the start/stop loco driver command but its not in the command menu. I check the session is Surveyor to see if the command is enabled and it is. So I created a basic coustom route to test it out and had the same problem.

Yes, I do have a driver assigned to it.

Anyone know why?

 

[SantaFebuff]

When you place the locomotive down in Surveyor, click the "?" mark and fill it up!

Cheers,
Joshua

 

[Trainboy103]

yeah, the fuel seemed to be the problem.

 

[woodieshouse1]

my l sd70 conrail works perfect but the l sd70 norfolk southern & l sd 70 ic the game exits it self then it goes back to the desktop???????

 

[PereMarquette1225fan]

What's Going On?

I noticed that today. I had the Conrail SD0M and a single Autorack filled with the invisible car cargo and a centerbeam with untreated railroad ties. I gave it fuel and sand and I ran it on Neuman706's NEC route. I was in Surveyor mode and I gave it a test to see, because I only use them in 2006. It starts, moves a few minutes and it shut the game down. I retried it, almost ten times before downloading the SD40-2 type diesels and well they ran, but the SD70Ms didn't, so I'm wondering what gives.