AI tells me some crappy and totally idiotic messages

[flusi737]

 

[fran1]

I froze play at junctions and didn't see any signals. The sidings at 3.26 have buffer stops, they need also to act as a signal otherwise nothing will enter those sidings. Sidings at 1.48 similar. If you need consists to go to the end of sidings lay some invisible track with a signal after the buffer.
A thought, put the engine spec back into loco and remove the sound.

 

[flusi737]

Signals are there (again the invisible ones), i checked it with the HUD that they are all green. Also replaced them with bnsf signals, same result so i went back to the invisible ones (the real route has no signals) i added a 'wagon' enginespec to the Alco too.

 

[fran1]

Put a standard (engined) alco on the front, to check that it's not the modified one causing the issue.

 

[flusi737]

Put a standard (engined) alco on the front, to check that it's not the modified one causing the issue.

Kay, will try that in 1h when i'm back on my pc

 

[fran1]

You've manually driven the route to check the track is ok.
Also, just place 1 loco on the route and check it will go to/from all destinations.
Just had one of mine "waiting for track clearance", solution was instant unload, to much weight to get moving.