AI Problem with Trackmark

[Tromben]

If AI drive forward so are that no problem but Do AI reverse to Trackmark do then not find then (this is if then have couple wagons)...

And i have try now, AI can´t find nothing, i try AI reverse to Industry same there AI reverse then direction Junction are when i start up drive session NO PATH, but forward its ok...

What happen ???
Why AI do so???

 

[carr]

TrackMark

Do you have the trackmark too far away? does the train have to go though several points to get to to it? Have you put in all the signals? Is it too close to a buffer where the train can't read it? It it facing the right way?

Lets say you have trackmark 'A' which the train will run to but will not reverse to trackmark 'C'.

One way that I have found is to put in another trackmark and in driver set up select Via trackmark 'B' ensuring that both B & C both have the back of the trackmark facing the train.

Also if you have altered the track, a point lever may have gone missing check and install one.

 

[Tromben]

I have check all point level its ok, and i have signal before all Point level(junction).

If i try ex. Drive to Industry that are the same,
drive forward go AI direct to destination but not reverse....

 

[Tromben]

Trainz are not there yet...

To real railroad Simulation......

I was to close to point lever (Junktion) go to Trackmark.....