Recent content by Richard_Dodge

Hi When working in surveyor the track spline points disappear when I move to another mode. I must have accidently pressed a key that set up this situation. I am working with TS2010 SP3. When I started using 2010 the track splines always stayed active. Any suggestions to fix this problem...

Hello to all. I have a couple of questions pertaining to steam operation. Where would one find the tutorials pertaining to steam locomotive operation? I did some searching but had no luck. Auran lists tutorials but can not locate them either. I am working in 2010 SP3. I have a...

Hi Bridges, Tunnels and Grade crossings usually have one or two guard rails set on the inside of the main rails. I did some looking on the DLS but so far have not seen any assets pertaining to the above subject. Any one know of such assets mentioned above. This should be for all gauges...

”You can set the radius in Surveyor and it is saved from then on. Select the junction lever where you want to change the radius. In the track menu go to the Right hand menu, click on Advanced. You will see three buttons. Left-hand is 'Get Radius', the centre is 'Set Radius' and the right-hand...

Hello to all: I am looking for some KUID number assets along with their identity names and who also created them so they can be loaded into 2010. The list is as follows: <kuid:43955:50005>,<kuid2:43955:50062:1>,<kuid2:43955:50063:1>,<kuid2:43955:50064:1>. The above kuids are listed as...

Hi I am building a system which requires duel rail (STD gauge with a third rail set inside to accommodate 36 inch NG), similar to Denver and Rio Grande RR at Antonito, CO November, 1968. Ref. Book “Ticket to Toltec” pg. 69. Please note I am not copying this track system. Only using the...

Hi to every one. Would like to make a video of my routes that I have developed so I can run it on a DVD player to show my friends and relatives. What tools do I need to accomplish this task and are there tutorials that I can download pertaining to this subject? Thank you and have a good...

Hi: Need advice on correct procedure for copying my works in TS2010, to an external hard drive. I have copied TRS2006 (local) to an external hard drive. But not sure which folder I should be copying from in TS2010! The folders listed in TS2010 are bin, Builtin, cache, controllers, Extras...

Before I get into discussing 2010 I want every body to know what is said here is not supposed to be on the negative side. Just want to try and get some answers. I have 2010“build 42203 “ installed that has SP`s included and have run some of the sessions. So far they all are running ok. I...

Before I get into discussing 2010 I want every body to know what is said here is not supposed to be on the negative side. Just want to try and get some answers. I have 2010 installed with no SP`s attached and have run some of the sessions. So far they all are running ok. I like 2010 for...

I was wondering if I will be vilolating any forum rules if I want to place the same comment in two places such as General Trainz and TS2010? Thank you and have a good day. Richard

Hello to all: Just a thought about the possibly that Microsoft Windows XP SP3 might be causing some of the problems that we are having with TS2010 in regards to Assets not being loaded, as they should be, due to having descriptions etc. I have learned that SP3 has some glitches in it that...

What is going on with the download Station? Have been trying to download items and all I getting is a message that I am not registered or ?. Been a member since 2004. Any thoughts on this dilemma. Thank you and have a good day. Richard

Hi Have a dilemma. When in Driver and wish to save the session all I get is a blank window which does not list any of my routes. I think I may have accidentally changed a rule that saves the Driver sessions. Any suggestions will be greatly appreciated. Thank you and have a good day. Richard

What`s happened to the Down Load Station? Iam not able to actuate it the last few days. Is it down for some reason? Richard