Recent content by CAREL_RICHTERS

Hello J Citron I have read your response and thank you for the effort you made to answer me. However, I fear that I can do little with this. I've noticed that the logic of the block system in Trainz Plus works slightly differently than in previous versions. This requires a different setup of the...

I am a beginner in the field of automation with Trainz. I know a few things, for example: the logic of a block system in Trainz Plus; which Trainz signals I need for this; how to set up an AI train. Knowing the logic of Trainz does not mean that I can apply it well, because a locomotive does not...

Om met de automatisering van mijn baan in Trainz tw leren kennen heb ik een rail ovaaltje bestaande uit 6 blokken gemaakt twee aan beide lange zijden en vier in beide ochten in elke bocht twee .De seinen staan juist opgesteld, De Track Circuit Markers (TCM) liggen onmiddellijk achter de seinen...

I am sorry for responding so late to your extensive message from January 30. I’ve been busy with all sorts of things. In the meantime, I have tried to apply your advice, but unfortunately, I did not succeed in achieving the intended goal. This is mainly due to my lack of knowledge and...

Hoi G.M. I apologise for my late reply. As you can see here, there is another person too, who I had to answer. In the meantime I tried to find a solution myself for both problems. With the other problem I succeeded. With this problem I didn’t. I can’t find the version number, you asked for...

Hi John, I am sorry for replying so late, but I just discovered that the cause of the crash was completely different from what I initially told you. I misled you with my information that Trainz had crashed and that, after reopening Trainz and the Edit Session, the Set Junction setting had...

In the bloksystem trains have to stop before a red Signal. The red/green change is automatical. One would expect the stopping of a train is automatical too. But a train doesn’t stop. Does any one know why, or what is the solution?

I am experiencing an issue in Trainz where the Set Junction rule has disappeared from the Edit Session under Rules. This occurred after a system crash that required me to restart my Mac. Restarting both Trainz and my computer did not resolve the problem. Has anyone encountered this issue before...

Thank you for your answer. I also found it in my mailbox. I am goimg to try it. If I still have questions, i hope I can put them to you.

I would like to automate my railway system. To test this, I have built a small test track consisting of an oval with a passing loop on both long sides. I have divided the track into six blocks: two blocks on each short side and one block on each long side. The passing loops share the same block...

I found the solution. There gad been made a number of sessions, not meant. I always opened the last session. That wasn't the right one. I had to open the Route and delete the unwanted sessions. So I have done now. After closing and reopening the Route the trains were saved. Thank you for your...

Since the release of Trainz plus the trains I have put on the rails have gone after closing and reopening the rain track what I am building. The reason why I put this question that late is that I was still building the track snd i only used trains for testing, However now I am ready with it, I...

After

Who knows how this turntable works? I tried several forums, but nobody knows the right answer. At every solution a train derails. First attaching the stubs to the yard rails, pointing to the pivot and then attaching to the pit and only in that sequence doesn’t work: the train derails. I only can...

There are two turntables in the content Manager: NSW turntable and 297 120 ft Turntable. The first has standard two attachments in a corner of 180 degrees, and stops only there. If I look in the coffig.txt of this turntable there are 24 attachment possibilities of which only two are in use. I...