Ok, so I'm currently so I've been creating a train carriage in gmax, I've added all the associated attachment points such as a.limfront, a.limback, a.bog0 and a.bog1 and I then exported it into trainz, it gives me no errors as I've included a shadow mesh, and I think I've done everything by the book including remembering to tick the Autocreate box on the default mesh, but when I place the train in surveyor it simply refuses to show, not even the consist arrows show up.
So I check if it's a fault with the scale by creating a version of the carriage as a scenery object, so everything is fine with that the scale is right. I've checked if the carriage is orientated the right way in gmax so the front of the carriage faces to the left when viewed in the right hand viewport. If anyone can help me it would be much appreciated.
By the way I'm using TS10 in compatibility mode.
So I check if it's a fault with the scale by creating a version of the carriage as a scenery object, so everything is fine with that the scale is right. I've checked if the carriage is orientated the right way in gmax so the front of the carriage faces to the left when viewed in the right hand viewport. If anyone can help me it would be much appreciated.
By the way I'm using TS10 in compatibility mode.
Last edited: