I post this here because the anomaly has been with me at least since 09, and persist even today in TANE:
You run your train, AI or manual. There is a schedule, so in AI, it arrives to a site where a helper is needed to go up a grade. You couple a helper in front of your engine, and manually you go up the grade. When the consist arrives to the top. you uncouple the helper and take it to a siding. Go back to the engine and order the train to continue the schedule. But the schedule is gone! Then you open the command menu and look for a "drive to track mark". Not there! the menu is very small with few basic commands. Way around this? Open the consist tab, find a similar engine and delete the "bad" one, insert the new one and presto! all the commands are there so you can make a new schedule.
As it is now, Trainz does not allow double heading ( it does, but you lose basic functions). I recall long ago someone talking about this. Or I am missing something here, or there is a bug/flaw, and it has been around for too long...
You run your train, AI or manual. There is a schedule, so in AI, it arrives to a site where a helper is needed to go up a grade. You couple a helper in front of your engine, and manually you go up the grade. When the consist arrives to the top. you uncouple the helper and take it to a siding. Go back to the engine and order the train to continue the schedule. But the schedule is gone! Then you open the command menu and look for a "drive to track mark". Not there! the menu is very small with few basic commands. Way around this? Open the consist tab, find a similar engine and delete the "bad" one, insert the new one and presto! all the commands are there so you can make a new schedule.
As it is now, Trainz does not allow double heading ( it does, but you lose basic functions). I recall long ago someone talking about this. Or I am missing something here, or there is a bug/flaw, and it has been around for too long...