kaw4014
Member
I'm trying to set up AI trains to go in and out of a station so I can screenshot them. What I want to do is say: "Drive to station Trackmark > Wait 2 mins > drive to staging Trackmark" (I have track marks in the stations and large staging yards outside the set). So I ran a test, I had a train (an NJT GP40PH-2B with 6 NJT Comet cars) go from a staging track to the station wait 30 sec and drive to staging. But it didn't move at all even though I waited for a while.
Things I tested:
On the same route I put down a straight track, a trackmark on one end and an engine on the other end and told it to drive to that track mark. It moved correctly in Driver mode.
I tested if some of the engines I was using wouldn't work with these commands so I made the setup i used above for each engine separately and ran it. Every engine moved correctly.
I added one car to each train (The Acela got an Acela car, the P42 got an Amfleet car and so on. Now only one of the six trains moved (The NJT GP40PH-2B with an NJT Comet car) the rest did nothing.
Extra info:
I'm using the NEC Wilmington - Philadelphia route, which is huge. I only want one station on one end of it, so I deleted 9/10 of the map's baseboards to improve performance.
At all times there were many trains placed at once. ~20-30 trains
When I go into the "Driver Setup" sometimes instructions I previously put in are gone.
When I go into the "Driver Setup" and select Drive to and then go to choose a trackmark, they are broken up into sections I didn't make (probably made by the map creator) that are also very unorganized. The 50 or so trackmarks I placed and named are scattered throughout these tabs
Things I tested:
On the same route I put down a straight track, a trackmark on one end and an engine on the other end and told it to drive to that track mark. It moved correctly in Driver mode.
I tested if some of the engines I was using wouldn't work with these commands so I made the setup i used above for each engine separately and ran it. Every engine moved correctly.
I added one car to each train (The Acela got an Acela car, the P42 got an Amfleet car and so on. Now only one of the six trains moved (The NJT GP40PH-2B with an NJT Comet car) the rest did nothing.
Extra info:
I'm using the NEC Wilmington - Philadelphia route, which is huge. I only want one station on one end of it, so I deleted 9/10 of the map's baseboards to improve performance.
At all times there were many trains placed at once. ~20-30 trains
When I go into the "Driver Setup" sometimes instructions I previously put in are gone.
When I go into the "Driver Setup" and select Drive to and then go to choose a trackmark, they are broken up into sections I didn't make (probably made by the map creator) that are also very unorganized. The 50 or so trackmarks I placed and named are scattered throughout these tabs