ATLS Crossings and Stopped Amtrak Trains? ATLS Corrector??

Williamb73

New member
Hey guys!

I'm building the Central Valley Sub in California on the BNSF track and I had a question regarding crossing gates going up to clear traffic while the Amtrak is stopped at the station? How could I do this? ATLS Corrector? Setting up the SPL Stuff???:sleep:

Sorry if this is an easy one? here a picture for an example.
trainz20120713081345810.jpg
[/URL] Uploaded with ImageShack.us[/IMG]

This Train will wait for 5 to 7 minutes and I need the gates to go up for traffic to clear?

CHeers, William
 
What I recomend is to change the priority of the stopping trains to another priority setting, then find the ATLS trigger(s) that is/are activating the crossing, editing that trigger to "X" out the priority level of the stopping trains and use the ATLS driver command immediately after the 5-7 minute wait. Then add a 5-10 second wait after that to give the crossing time to fully set. Then the trains may proceed as normal. This will prevent the crossing from activating for any trains taking a pause inside the crossing zone, while letting the nonstop trains to activate and cross over as normal.
 
Back
Top