Heathrow Airport

Thanks paganwolf
Tried to get it as near as possible right from images that are available. Think I got most of it right with the assets available and hope it works ok for you.
 
Operating Heathrow airport

Some questions ive had on how to run the airport. You need the Heathrow 2 session so the system can be set up right. The basic rule ive used for TM's and commands are:-
Cat 1 = Large and fast aircraft
Cat 2 = Medium aircraft
Cat 3 = Small aircraft
Cat 4 = Light aircraft (Cessna)

Landing uses the basic rules, a Cat 1 will land and follow all the runway to the Cat 1 landed TM while Cat 4 will use a shorter landing to Cat 4 landed TM. Aircraft will leave the runway at the first exit after their Cat landed TM.

Take off also uses the basic rule with the exception of Cat 4 which uses Cat 3. Cat 1 uses all the runway for take off while Cat 3 uses a shorter take off.

Gates and parking areas use the basic rule to determine the max size of aircraft it can except. There is also a Cat 1+ TM which is for the new A380 aircraft. Any aircraft can use the TM's up to the Cat number so a Cat 3 aircraft can use a Cat 1 TM but a Cat 1 aircraft cant use a Cat 2 TM because it will be to big for the space. All TM's are named with the terminal number, Cat number and gate number.

Taxi way TM's are set up with the letter or number of the taxiway except for A and B. A and B go all round the airport and the TM's are named by their location, An = taxiway A north side, Bs = taxiway B south side etc.

Use the abort command between the outer marker and inner marker commands for the aircraft to abort landing and go around again. Touch and go by using the landing schedule followed by the drive via Cat ? take off TM. This will then land and take off.
 
Avaliable for older versions?

Is there anyone who could to backdate this down to 06 or instructions on how to backtrack? (Bump)
 
Last edited:
Back
Top