New Water Effect

Hi all,

Just a quick one; I've had a trawl through various posts on the topic but I can't see that anyone has run into this issue yet, though I'm sure someone, somewhere, has.

When I try to upgrade the legacy water on my route to the new water effect layer, I get the following error message but I don't understand it - it doesn't indicate which layer is the issue nor how I can 'reconfigure' it. In the screenshots you can see my existing layers on the right:




Has anyone come across this yet and does anyone know which area I should be looking in to fix it?

Cheers,

PLP

You may need to reduce the Density of other effect layers... have a look at this:

https://online.ts2009.com/mediaWiki/index.php/Effect_Layer_Data_Binding

you can edit the effect layers from the edit menu.

The layer is not in the layers you see in the route or session sections. Water gets stored in the effects layer which is located in the topology tab and under advanced. Click on ground will show the different effect layers you have used. As in the chart below each effect layer uses differing amounts of space and data.