Copying Transdem UTM-layer from one route to another route in TRS2019?

belgian46 · Mar 10, 2023

Hello,

Has anyone tried to copy a Transdem UTM-layer from one route to another route in Trs2019?

If yes, what method did you use?

Kind regards

Kurt :wave:

HiBaller · Mar 10, 2023

I haven't tried this, and couldn't tell you the results, but I would use the CM to list dependencies, then gather all the UTM tiles into one big CDP file and save it. Open the new route and make sure you have the same amount of boards as the original, then use CM again to import the tiles and put them on a separate layer again.

Bill

belgian46 · Mar 10, 2023

HiBaller said:
I haven't tried this, and couldn't tell you the results, but I would use the CM to list dependencies, then gather all the UTM tiles into one big CDP file and save it. Open the new route and make sure you have the same amount of boards as the original, then use CM again to import the tiles and put them on a separate layer again.

Bill

Hello Bill,

Thank you for your reply. I have put your solution for further investigation on my drawing board.

Kind regards

Kurt :wave:

Copying Transdem UTM-layer from one route to another route in TRS2019?

belgian46

Active member

HiBaller

19 Years of Trainz

belgian46

Active member

Similar threads