Auto Drive Past Junction - Query

TonyN

Active member
Hi
Have been playing with the AutoDrivePastJunction driver command by atilabarut. When selecting the command, the options of "InnerLeave" and "Leave" are displayed followed by the junction selection. Can anyone out there explain what this means as I can find no difference between the two options.

Thanks in advance
 
As a side note, this thread should probably be moved to the Surveyors, Operators.... forum.

The junction has a radius associated with it (similar to a track marker) which can be adjusted if desired. Inner leave will consider the junction passed when the rear of the consist has crossed over the junction itself. Leave will consider the junction passed when the rear of the consist has left the edge of the junction radius. Inner leave can thus be useful in tight yard areas, for example, without the need to go in and edit each junction's radius setting.

The above is my understanding, based on some hands on experience, but may not be 100% accurate.
 
Back
Top