PortLineParker
UK Route Builder
Hi all,
I'm making some sessions for a route and I set the headcode accordingly in Surveyor, but when I later launch the session the headcode has disappeared and it needs setting up again.
Is there a way to keep the headcode and other loco options (such as ANR pods, high density lights etc.) set in Surveyor to appear in driver? This happens with both steam and diesel locos, although this specific example refers to a steam loco.
**Edit**
So I've managed to set the headcodes using the Train Reporting Basic rule, but this sets them at both ends of the loco. Is there a way to set it on one end only?
I still haven't managed to figure out how to set the other loco options, such as ANR pods, high density lights etc. so any help on that would also be appreciated!
Cheers,
PLP
I'm making some sessions for a route and I set the headcode accordingly in Surveyor, but when I later launch the session the headcode has disappeared and it needs setting up again.
Is there a way to keep the headcode and other loco options (such as ANR pods, high density lights etc.) set in Surveyor to appear in driver? This happens with both steam and diesel locos, although this specific example refers to a steam loco.
**Edit**
So I've managed to set the headcodes using the Train Reporting Basic rule, but this sets them at both ends of the loco. Is there a way to set it on one end only?
I still haven't managed to figure out how to set the other loco options, such as ANR pods, high density lights etc. so any help on that would also be appreciated!
Cheers,
PLP
Last edited: