captainpugwash
New member
Hi, can anyone tell me why, when using AI instructions, it flips to "this train is not under user control"? For no apparent reason, like riding a red signal, I lose control.
Build 117009. Whilst using Georgetown to Tarin Rocks, I initially used engines NSWGR class 43 loco's on my consist, when I went to "drive" the AI instructions were taken off-screen and the message "this train is not under user control" came up. I experimented with different things but the problem seemed cured when I replaced the 2 class 43's with class 45's. However, an hour and ten minutes into the session, loading/unloading, picking up and dropping off wagons, it suddenly flipped into no control mode after I add another 2 locos to the consist. Another thing that happened was just before it flipped I tried to stop the train by going to the AI instructions and using stop train, but all it would let me do is "add driver" or "get off train". Whilst not under driver control it still carries out the AI instructions.
Build 117009. Whilst using Georgetown to Tarin Rocks, I initially used engines NSWGR class 43 loco's on my consist, when I went to "drive" the AI instructions were taken off-screen and the message "this train is not under user control" came up. I experimented with different things but the problem seemed cured when I replaced the 2 class 43's with class 45's. However, an hour and ten minutes into the session, loading/unloading, picking up and dropping off wagons, it suddenly flipped into no control mode after I add another 2 locos to the consist. Another thing that happened was just before it flipped I tried to stop the train by going to the AI instructions and using stop train, but all it would let me do is "add driver" or "get off train". Whilst not under driver control it still carries out the AI instructions.