Issue loading locomotives and trains onto routes

Hello, thought to ask to help fix an issue with trainz 2019.

the main problem is that some assets won't want to load though every kuid is working fine. how it normally plays out is the kuid will show at the top once clicked on a loco to place down in the editor, after the hourglass shows for a couple seconds a buzzing sounds briefly when after I click on the track after the icon disappears.

Not sure what can be done about it

Could you post a few kuid values for some of the offending locos so that we can check? Your post is a bit "too vague" to be able to give a definitive diagnosis.

There are a number of things that can cause this.

If a switch is set against the track where you want to place the locomotive and you are trying to place the locomotive on the switch, this will produce the buzz and not allow you to do so.

If there are splines in the way such as power lines or catenary, this can make placing locomotives and trains in general difficult as well. You sometimes have to get the mouse positioned just right before you click and place the train.

If there's a broken spline point where you're placing the train, this will also cause this.

Hope this helps

pware said:

Could you post a few kuid values for some of the offending locos so that we can check? Your post is a bit "too vague" to be able to give a definitive diagnosis.

Click to expand...

I can give the various add-ons which are causing the problems along with some with Kuids

JR East 211 (Kuid:668654:103355)
JIRC 223
JR Central 331 (Kuid:668654:103605)
JR Central 211 - 6000 (Kuid:668654:103336)
JR Central 211 - 5000+6000 3+2 Single Arm Pantograph (Kuid:668654:103338)


well going by most of them the common problem is they are all listed to be made by AlexMaria recently