Run around problem

Hello

I have a stupid problem when trying with Kickstarter County 2 session on Trainz 2019. It is not possible to run around the train as when I'm trying to couple at the another end there is the red signal before the switch, making impossible to approach the first car for coupling. The same problem occurs if I'm trying to use automatic run around procedure. How to overcome this issue?

regards
Tomasz

Shot in the dark here. Try a "logical" reverse to "swap ends" (forward is backward and vice versa) of the loco and try. I'm curious as to if this helps.

And are you DCC or in Cab mode? Swap and see what happens.

Also, did you do a "save" and reload to continue later?

You can switch to DCC mode and just run through the signal.