Quick Portal Manager - 2nd train stops session.

boleyd

Well-known member
Quick Portal Manager uploaded on March 26th to DLS. TRS19 111381

Two Trains From Same Portal - same copy of the Manager.
Start train 1 ok
1 minute later train 2 starts ok

Both trains run properly until train 1 comes to the end of its schedule (stops).
When that happens train 2 (running) comes to a stop as well. Has not completed route.

The program is locked and has to be reloaded.

Re-running, same issue. Reported
 
Last edited:
Could you start the 2nd consist maybe at a 5 minute interval instead of 1 minute.
If you are producing consists from a portal, then it may be wise to set up an exit portal to take care of all consists that have finished their route.

Good luck,
Roy
 
Could you start the 2nd consist maybe at a 5 minute interval instead of 1 minute.
If you are producing consists from a portal, then it may be wise to set up an exit portal to take care of all consists that have finished their route.

Good luck,
Roy

Or just delete them with a driver command.
 
Just an update. Portals seem OK now. I am using 1 minute intervals as a stress test and it really stacks up the trains but no problems. I use Basic Portal.
 
Back
Top