tfr.stmalo
Member
Hi, everybody !
Here is an example :
As you can see, this is a static camera that was created in Route Edit mode. It is pointing at the signal and the distance between the two is 50-60 meters. So, as far as I can understand it should start whenever the loco gets near the signal / under the bridge. And that should work in any session.
Well, it doesn't. Never, ever. Same with trackside cameras.
Can you help? Thanks in advance.
PS: I use TRS2019 Platinum, build 110491.
Here is an example :
As you can see, this is a static camera that was created in Route Edit mode. It is pointing at the signal and the distance between the two is 50-60 meters. So, as far as I can understand it should start whenever the loco gets near the signal / under the bridge. And that should work in any session.
Well, it doesn't. Never, ever. Same with trackside cameras.
Can you help? Thanks in advance.
PS: I use TRS2019 Platinum, build 110491.
Last edited: