HELP junction auto drive navigate 2019

Hi
I am making an airport but am getting strange happenings.
I have set up two gates with track marks (gate 1 gate 2 )
They are off two separate junctions.
In AI I tell the plane to navigate to TM (gate 1) it sets the junction ok has a green signal but stops at the junction and will not proceed.
If I then delete navigate and enter AUTODRIVE command it continues to TM
The second TM (gate two) works fine.
I have deleted the TM and replaced it still the same
I have also Made a new one board route with the same junction's etc and planes that route is doing the same
Hope this makes sense.

BUILD 110491
Thanks for any help

Matt

What do you have at the end or terminus of those two "gate branches"? Are they terminated by signals i.e. invisible signals or similar?

hi yes invisible signals and the speed stutters before stopping at junction

just a update having to set both junctions now in right direction and Auto drive to TM

Hi all figured it out I had pushback tractors pasted the TM
I put a invisible junction past the TM and set the junction so the plane could not see the pushback.
now works fine
:hehe:
Thanks for your help
Matt