Disheartened over losing a lot work on the Uintah, I've retreated to a relatively easy job, revamping the Narrow gauge timber ridge to standard gauge,although its mostly a matter of replacing track and coaling trestles, water tanks and bridges to change * and the flipping tunnels -urggh ) , it also means redesigning some parts of the route such as Tollume pass as the curves are too tight and 6% grades are probably too steep to be prototypical., but it will allow 2-6-6-0 Mallets to pull up the 4'5% grades of the pass , i've also got to change the vegetation and as usual the winter section may look a bit weird as there are not many good snow covered speedtrees out there-anyone got any ideas for which to use?
. I will not be using turf fx or the fancy textures. So far 2019 had crashed on me five times, mostly when saving , which isn't very encouraging.
The 30 inch section will be changed to 3 ft so people will find it easier to run the NG section , i know much of the 30 inch rolling stock wasn't on the DLS and this caused many download issues .
entering the snowline
. I will not be using turf fx or the fancy textures. So far 2019 had crashed on me five times, mostly when saving , which isn't very encouraging.
The 30 inch section will be changed to 3 ft so people will find it easier to run the NG section , i know much of the 30 inch rolling stock wasn't on the DLS and this caused many download issues .
entering the snowline