Has anyone found a solution for this yet

I have a rather BIG problem with a trackmark in SP2 after installing the Illawarra route to test it.

I've done an extended DBR and checked in CM and trackmarks are marked as BASE, I really have run out of ideas this time. I recall seeing a post about this while trawling the forums whilst in hospital, but buggered if I can find it now.
Hopefully there is a solution?
I'm still building in SP1, but ideally would like to build in SP2 due to the better TurfFX interface
cheers
Graeme

hi Graeme,
This only shows in Surveyor, when you open the Tracks menu then select the trackmarks tab?
Can you make a screenshot when the trackmarks foldout is open? So we can see if there is an extra item.
This is not the built-in Auran trackmark from (2001-2021)
if you find the kuid, someone can fix it for you (i volunteer if its not payware or built-in)


greetings GM

It appears to be a Ranger51 signal causing the problem. At least there is something to work with

Now to see if I can fix it.
cheers
Graeme

G'day folks

Maybe?

Goto Tracks \ Add Trackmark \ Advanced.....

keep covid save every-one

Check to see if the 'radius' of the track-mark may have been set too high (500 max) ?

Just saw this in the Freeware section for Ranger51 signals. Maybe you will have an answer when this is available.