I have set up Enhanced Interlocking Towers (EIT) on a new route. It is on a route I created in TANE and am now updating to TRS2019. The problem is that the EIT is not working in Automatic mode. Briefly, I send a consist out of the terminus on to a variety of different routes. The departure & Arrival procedure I want to handle automatically. The paths are set up correctly and a consist on say platform 3 is given a schedule library command. The initial departure path is set and the consist should drive via its first marker 'Departure'. The problem is that the entry signal stays on stop. Looking at enhanced mgt rule shows that the path has not been set. The same system works perfectly on another route but not on this one. When I go to ITSetPath rule in the drive menu, it shows that the Entry signal as active and clicking it operationalises the path and a second later the signal goes green and the consist departs. But it won't happen automatically. Have tried deleting the tower and recreated the paths but to no avail. Any ideas!!??