What does it mean if I can't join two sections of track? I can join them by placing a separate short section between them.
These are the SAP TRS19 132lb series. I have had this before over several years. Normally I just stick in a new short section
and move on. However, this time during a RUNAROUND the train refuses to enter the "repair".
Note: many miles away there are two trains on-track.
============================================
I just kept deleting sections of track until I found one that would accept a Join. This has been around
for a long time, at least in my experience.
These are the SAP TRS19 132lb series. I have had this before over several years. Normally I just stick in a new short section
and move on. However, this time during a RUNAROUND the train refuses to enter the "repair".
Note: many miles away there are two trains on-track.
============================================
I just kept deleting sections of track until I found one that would accept a Join. This has been around
for a long time, at least in my experience.
Last edited: