steverozuk
Member
Hi
I have noticed an inconsistency the way some splines are displayed during a driving session.
90% of the time everything runs smoothly with no problems at all.
Sometimes (randomly) 1 or more splines don't display and pop into view when you get close to them.
This happens with fences, walls, telegraph lines etc with never more than 2 splines showing this behaviour and not the same ones when this does happen.
Typically walls on bridges show themselves only when you are very close and splines that run down line don't show in the distance and sections pop into view the closer you get.
As I say this happens randomly and I would have thought if a spline was faulty it would happen every time.
Anyone else seen this?
I assume it is something technical and would love to know for my own knowledge if someone has the answer and also if there is a way to fix it.
Thanks
I have noticed an inconsistency the way some splines are displayed during a driving session.
90% of the time everything runs smoothly with no problems at all.
Sometimes (randomly) 1 or more splines don't display and pop into view when you get close to them.
This happens with fences, walls, telegraph lines etc with never more than 2 splines showing this behaviour and not the same ones when this does happen.
Typically walls on bridges show themselves only when you are very close and splines that run down line don't show in the distance and sections pop into view the closer you get.
As I say this happens randomly and I would have thought if a spline was faulty it would happen every time.
Anyone else seen this?
I assume it is something technical and would love to know for my own knowledge if someone has the answer and also if there is a way to fix it.
Thanks