I have a session with 4 trains, 3 of them use the"Wait for Trigger" command. I open the session and check the WFT command....it is not "greyed out" and the List is there.
OK,
I add another loco/train and I want it to use that command.
BUT, I cannot select it from the command list, because it is "greyed out".
Now, I check one of the other trains and lo and behold, "Wait for Trigger" is "greyed out" also, but the command still works when the train is running.
I cannot get the WFT command back until I leave surveyor and return.
Different Subject;
A I see it, the new "unified surveyor" is only of use during route construction.
It is useless (almost)during the running of a session. Useless, that is, unless you want the trains spread all over your map the next time you run the session.
In other words, returning to the session from surveyor does NOT SAVE the changes you made (if you leave the session without saving), what a PITA!!
Dave
(Flame suit ON, running shoes ON)
OK,
I add another loco/train and I want it to use that command.
BUT, I cannot select it from the command list, because it is "greyed out".
Now, I check one of the other trains and lo and behold, "Wait for Trigger" is "greyed out" also, but the command still works when the train is running.
I cannot get the WFT command back until I leave surveyor and return.
Different Subject;
A I see it, the new "unified surveyor" is only of use during route construction.
It is useless (almost)during the running of a session. Useless, that is, unless you want the trains spread all over your map the next time you run the session.
In other words, returning to the session from surveyor does NOT SAVE the changes you made (if you leave the session without saving), what a PITA!!
Dave
(Flame suit ON, running shoes ON)