Hmmmmm, I wonder...

What I can do to get ver. 105100 to bring back my list of Triggers used in UMR 2020.
I just tried to use a "Wait for trigger" command and it greyed out, no list of triggers.
Guess I will quit session creating until.......

DaveL

I just tried the "Wait for Trigger" driver command in 105100 and it was selectable, and all the triggers were listed and available for selection.

pware,

That is all well and good.
What I did not articulate well enough, is that when I started to write my session, The Trigger List was there a week ago. I used it in the session.
Now, the Trigger List has disappeared!!
I just rebooted the PC, so let me sneak up on it and see........No, not there.
But the list is there in an earlier route save.
I need a way to get it back, any ideas??

Dave

I was going to suggest deleting the WaitForTrigger driver command from Trainz and then reinstalling it but I just noticed that it is a "Built-in" so it cannot be deleted.

Clearly something else has changed since you last successfully used the command. Tracking down what will be the problem.