Howdy folks,
I wasn't sure where to put this.
I imported a route from '12 to '19. At first glance, everything looks fine, but apon going to wireframe mode, many of of the boards are missing the wireframe mesh. I know you can heal digholes using copy and paste, but no luck here.
I thought ...maybe,,,if I saved the route to a cdp...delete the installed route , then reinstall, it might force the program to rebuild the wire mesh.
Is there a fix for this? Anyone else run into the same problem?
Turning off wireframe and it looks fine, but trying to do any contour work, and it's obviously not "normal"
Thanks and everyone have a great evening!
I wasn't sure where to put this.
I imported a route from '12 to '19. At first glance, everything looks fine, but apon going to wireframe mode, many of of the boards are missing the wireframe mesh. I know you can heal digholes using copy and paste, but no luck here.
I thought ...maybe,,,if I saved the route to a cdp...delete the installed route , then reinstall, it might force the program to rebuild the wire mesh.
Is there a fix for this? Anyone else run into the same problem?
Turning off wireframe and it looks fine, but trying to do any contour work, and it's obviously not "normal"
Thanks and everyone have a great evening!