Trigger Multiple Signals

Ghost42

Well-known member
This command appears not to work in trs19, should it show up in 'Driver Commands'?
In the mean time I shall construct a test route and check it out.
My route has been imported from Tane, but all commands are showind and the command shows as installed.
Thanks for any help, it will stop my consists from 'virtually' being cut in half.
EDIT: It does work, I'll re-write the rules and check signal and trigger names.
 
Last edited:
Trigger Multiple Signals is a Session Rule, not a Driver Command (or not that I am aware of).
 
Back
Top