Grade crossings, traffic stoppers, and bulk asset replace

horacefithers

New member
I wanted to change a whole bunch of roadwork from one road spline to another.

The good news is I was able to get the bulk asset replace utility to do the dirty work.

The bad news is that ALL of the grade crossing TRC traffic stoppers that were installed suddenly went bald.
That is, the road "skin" that covered the traffic stopper disappeared.

The traffic stoppers also became incapable of being reconnected to roadwork - there were no "circles" where roads could be connected.

I ended up having to delete all the existing traffic stoppers, install new ones, then connect roads to the replacement traffic stoppers.

Has anyone else seen this problem?

Is it a bug in the TRC traffic stoppers or in the bulk asset replace tool?

Inquiring minds want to know...

Horace (who must have replaced around 30 traffic stoppers in the past week) Fithers
 
Back
Top