TRS2019 Build 103369
Been setting up some tunnels using dig holes and portals
After setting the portal I've been going into driver to a loco using ( cab camera ) just inside the portal to check for light bleed around the portal
Then when I go back into Surveyor and try to use a spline of any type track road fence wall etc all I see is the end point circles but nothing else
I can only see splines after saving and leaving Surveyor and saving then restarting
Have also cloned the route but it's still the same
Any Ideas as to whats causing this haven't come across it before
This happens every time I exit Driver now
The Route has no errors , warnings or missing dependencies
Surveyor before going into Driver
In driver most of the track is not visible as well the terrain textures and scenery items are effected
This what it looks like when I exit Driver and go back into Surveyor
Been setting up some tunnels using dig holes and portals
After setting the portal I've been going into driver to a loco using ( cab camera ) just inside the portal to check for light bleed around the portal
Then when I go back into Surveyor and try to use a spline of any type track road fence wall etc all I see is the end point circles but nothing else
I can only see splines after saving and leaving Surveyor and saving then restarting
Have also cloned the route but it's still the same
Any Ideas as to whats causing this haven't come across it before
This happens every time I exit Driver now
The Route has no errors , warnings or missing dependencies
Surveyor before going into Driver
In driver most of the track is not visible as well the terrain textures and scenery items are effected
This what it looks like when I exit Driver and go back into Surveyor
Last edited: