I'm using pguy's TRC Enhanced Interlocking Tower and associated driver commands. All are the latest versions. I'm also using the built-in IT SetPath and IT Cancel Path rules.
This is in the latest version of TRS2019, build 104261
I have found that whilst everything works perfectly with trains passing through the paths, when a path is cancelled without a train - ie by using the IT Path Cancel driver command or IT Path Cancel rule - the junctions do not reset direction. This is not a problem, as they would be reset on the next "set path" command.
But any signals that are set as objects "external to path" also do not reset, they stay on a "proceed" setting. This does cause problems, as any train approaching this signal can just proceed without a path actually set.
Any ideas?
This is in the latest version of TRS2019, build 104261
I have found that whilst everything works perfectly with trains passing through the paths, when a path is cancelled without a train - ie by using the IT Path Cancel driver command or IT Path Cancel rule - the junctions do not reset direction. This is not a problem, as they would be reset on the next "set path" command.
But any signals that are set as objects "external to path" also do not reset, they stay on a "proceed" setting. This does cause problems, as any train approaching this signal can just proceed without a path actually set.
Any ideas?