Does anybody know if there is a possible way to go into the config files of a particular road asset and disable traffic on that road?
The quality of the YARNish and AASHTO roads are so good I don't want to sacrifice taking them off my route, however I have a need for some roads to operate with no traffic.
In a section of my route I'd like to have the track run down the middle of a residential area, but the traffic on these particular assets just runs too close together for me to squeeze a locomotive in between them.
If there isn't a way to do this that's alright. What would be a good non-traffic road asset I could use instead?
The quality of the YARNish and AASHTO roads are so good I don't want to sacrifice taking them off my route, however I have a need for some roads to operate with no traffic.
In a section of my route I'd like to have the track run down the middle of a residential area, but the traffic on these particular assets just runs too close together for me to squeeze a locomotive in between them.
If there isn't a way to do this that's alright. What would be a good non-traffic road asset I could use instead?