Anyway to get cameras below ground without adjusting the ground?

Red_Rattler · Sep 10, 2019

This is mainly for TANE SP3/SP2, TS12, TS10.

Is their anyway to get the cameras below the ground - without adjusting the ground?

EG: https://imgur.com/46ktLaL

If you put cameras underground such as in the image, you need to adjust the ground using the down tool, then adjust the ground back to near where you need it. Unless you're using just flat ground, that would be difficult to get the exact same heights again.

(I haven't managed to have different heights for the ground yet.)

MP242 · Sep 10, 2019

I think the Camera height under the Camera asset itself, relies on a distant far away grid (which depends on the Camera focus/angle setting) to be height adjusted terrain, and lowering that distant height adjusted terrain grid, that then lowers the Camera FOV underground.

Roy3b3 · Sep 10, 2019

Red_Rattler said:
This is mainly for TANE SP3/SP2, TS12, TS10.

Is their anyway to get the cameras below the ground - without adjusting the ground?

EG: https://imgur.com/46ktLaL

If you put cameras underground such as in the image, you need to adjust the ground using the down tool, then adjust the ground back to near where you need it. Unless you're using just flat ground, that would be difficult to get the exact same heights again.

(I haven't managed to have different heights for the ground yet.)

In Surveyor mode and I need to adjust signals. track and tunnels,... I switch to grid display.

In Driver mode through tunnels,... I just use cab view.

If there is any better way, I'd like to hear it.

Cheers,
Roy

Anyway to get cameras below ground without adjusting the ground?

Red_Rattler

Since 09 May 2003

MP242

TRS2006 PRR Enola-Conway

Roy3b3

Active member

Similar threads