Red_Rattler
Since 09 May 2003
This is mainly for TANE SP3/SP2, TS12, TS10.
Is their anyway to get the cameras below the ground - without adjusting the ground?
EG: https://imgur.com/46ktLaL
If you put cameras underground such as in the image, you need to adjust the ground using the down tool, then adjust the ground back to near where you need it. Unless you're using just flat ground, that would be difficult to get the exact same heights again.
(I haven't managed to have different heights for the ground yet.)
Is their anyway to get the cameras below the ground - without adjusting the ground?
EG: https://imgur.com/46ktLaL
If you put cameras underground such as in the image, you need to adjust the ground using the down tool, then adjust the ground back to near where you need it. Unless you're using just flat ground, that would be difficult to get the exact same heights again.
(I haven't managed to have different heights for the ground yet.)
Last edited: