Quick Drive

big_b

Active member
In build 100464 where are the manual driver controls now
Like the dial controller in Tane
I just want to check some tunnels for light bleed
 
Thanks knew there were dots or something somewhere
Turns out I had my resolution up a bit high and I couldn't see them
 
Still have problems resolution set at 1920 x 1080 not full screen
In the first picture this is a basic one board map for testing various things all the Driver Controls can be seen in driver
The second is my Route the same resolution in use but only some of the Driver Controls are visible
Any ideas whats going on ?



forensic anthropologist salary canada
 
In the first one you have an allocated driver shown. In the second you have no allocated driver shown. Controls only appear if you select an allocated driver.
 
Back
Top