horacefithers
New member
I've been using TurfFX with success (other than confusion about what all the parameters do...), however I watch the tutorial on the N3V games YouTube channel "long seed grass" https://www.youtube.com/watch?v=l04As0QFFPQ and got a message in red at the bottom of the TurfFX dialog box that seemed to say I was overflowing some kind of internal table.
My "route" currently has 109 squares in it, so I tried again with a single square test route. This time everything worked OK.
So I tried again with the big route and monkeyed with the settings a bit. I managed to get the red messages to go away although there was an orange message. I clicked "accept" and that seemed to work also.
I'm running TRS 2019 on an AMD 2950x cpu with 64gb of ram and a 11gb gpu card so I would hope I'm not out of system memory yet...
Is there a magic configuration file setting somewhere that would increase the size of the table in question?
Regards,
H. Fithers
My "route" currently has 109 squares in it, so I tried again with a single square test route. This time everything worked OK.
So I tried again with the big route and monkeyed with the settings a bit. I managed to get the red messages to go away although there was an orange message. I clicked "accept" and that seemed to work also.
I'm running TRS 2019 on an AMD 2950x cpu with 64gb of ram and a 11gb gpu card so I would hope I'm not out of system memory yet...
Is there a magic configuration file setting somewhere that would increase the size of the table in question?
Regards,
H. Fithers