Heinrich505
Active member
I'm having trouble with this session in TANE. I get to the coal consist but once connected, I can't seem to get up the incline pulling the coal cars. Same thing happens in TRS2019 but Tony said they are working on some problems with the session for that, so I figured I would just run TANE for now, but still no luck here either. First time running the 2-6-6-6. I must be missing something.
I'm in cab mode, and I've tried various combinations of regulator and cut-off, but I can't seem to get the train moving. I've applied the sander too. No luck. I can get a little movement, but then I lose momentum and end up stopped. I've even tried rocking the engine back and forth a bit, reverse and then forward, and that sometimes gets the wheels moving slightly forward, but then everything stops again.
Suggestions are welcome. Of course I can always use DCC and get past that point, but that takes away the challenge.
Thanks,
Heinrich505
I'm in cab mode, and I've tried various combinations of regulator and cut-off, but I can't seem to get the train moving. I've applied the sander too. No luck. I can get a little movement, but then I lose momentum and end up stopped. I've even tried rocking the engine back and forth a bit, reverse and then forward, and that sometimes gets the wheels moving slightly forward, but then everything stops again.
Suggestions are welcome. Of course I can always use DCC and get past that point, but that takes away the challenge.
Thanks,
Heinrich505